Condition Assessment of Existing Concrete Building Using Non-Destructive Testing Methods for Effective Repair and Restoration-A Case Study
Abstract
Buildings constructed during early 70’s & late 80’s of the last century in India are found to be in distressed conditions due to inadequate specifications and poor construction practices. The continuous monitoring of concrete structures using suitable NDT (Non Destructive Testing) methods and use of possible restoration methods help in a considerable reduction of the rate of deterioration of concrete structures thereby increasing the life span of structures. NDT methods have greater advantage in evaluating the uniformity, homogeneity, approximate compressive strength, durability, the extent of corrosion of rebars in concrete etc. of damaged structures. The objective of the present study is to enhance the life of 50 year old existing hospital building (Partly RC and Brick masonry) in Kurnool, Andhra Pradesh. Condition assessments are carried out through a visual, field and laboratory evaluation of samples collected from the structure and results are presented in this paper. The paper also highlights the assessment of strength and durability of concrete to evaluate the extent of distress and damage in the building. Besides visual inspection, the Non Destructive Evaluation covering UPV & Rebound Hammer values and Half Cell Potential with respect to the status of corrosion of reinforcing bars and chemical tests on selected un-distressed RC columns, beams, and slabs are also presented and discussed. The repair and strengthening techniques using the latest materials and possible restoration works such as column jacketing, shotcreting, anticorrosive coatings, etc. have been suggested to enhance the life of the structure.
Keywords
References
Chunhua Lu, Weiliang Jin, Ronggui Liu, “Reinforcement Corrosion-Induced Cover Cracking Ans Its Time Prediction for Reinforced Concrete Structures” Corrosion Science, 53, (2011) 1337-1347.
Amir Poursaee, “Corrosion measurement and evaluation techniques of steel in concrete structures” Clemson University, Clemson, SC, USA.edition, year of publication.
John P Brromfield, “Corrosion of Steel in Concrete- Understanding- investigation and repair” 2nd edition, year of publication, Taylor and Francis publications.
M. Torres-Luque, E. Bastidas-Arteaga, F. Schoefs, M. Sánchez-Silva, J.F. Osma, “Non-destructive methods for measuring chloride ingress into concrete: State-of-the-art and future challenges”, Construction and Building Materials, Volume 68, 15 October 2014, Pages 68-81, ISSN 0950-0618.
Malcolm K. Lim, Honggang Cao, “Combining multiple NDT methods to improve testing effectiveness”, Construction and Building Materials, Volume 38, January 2013, Pages 1310-1315, ISSN 0950-0618.
Helal, J., M. Sofi, and P. Mendis. "Non-destructive testing of concrete: A review of methods." Electron. J. Struct. Engnr 14 (2015): 97-105.
Sardar Kashif Ur Rehman, Zainah Ibrahim, Shazim Ali Memon, Mohammed Jameel, Nondestructive test methods for concrete bridges: A review, Construction and Building Materials, Volume 107, 15 March 2016, Pages 58-86, ISSN 0950-0618.
Lamya Amleh, M. Saeed Mirza, “Corrosion Response of a Decommissioned Deteriorated Bridge Deck”, JOURNAL OF PERFORMANCE OF CONSTRUCTED FACILITIES, Vol 18(4), Pp.185-194, NOVEMBER 2004.
Abdulkader El Mir, Salem G. Nehme, “Repeatability of the rebound surface hardness of concrete with alteration of concrete parameters”, Construction and Building Materials, Volume 131, 30 January 2017, Pages 317-326, ISSN 0950-0618.
Jin-Keun Kim, Chin-Yong Kim, Seong-Tae Yi, Yun Lee, “Effect of carbonation on the rebound number and compressive strength of concrete”, Cement and Concrete Composites, Volume 31, Issue 2, February 2009, Pages 139-144, ISSN 0958-9465.
Ourania Tsioulou, Andreas Lampropoulos, Spyridon Paschalis, Combined Non-Destructive Testing (NDT) method for the evaluation of the mechanical characteristics of Ultra High Performance Fibre Reinforced Concrete (UHPFRC), Construction and Building Materials, Volume 131, 30 January 2017, Pages 66-77, ISSN 0950-0618.
M. Yaqub, C.G. Bailey, Non-destructive evaluation of residual compressive strength of post-heated reinforced concrete columns, Construction and Building Materials, Volume 120, 1 September 2016, Pages 482 493, ISSN 0950 0618.
Veerachai Leelalerkiet, Je-Woon Kyung, Masayasu Ohtsu, Masaru Yokota, “Analysis of half-cell potential measurement for corrosion of reinforced concrete”, Construction and Building Materials, Volume 18, Issue 3, April 2004, Pages 155-162, ISSN 0950-0618.
Bungey, John H., Michael G. Grantham, and Stephen Millard. Testing of concrete in structures. Crc Press, 2006.
Jin Xia, Wei-Liang Jin, and Long-Yuan Li, “Performance of Corroded Reinforced Concrete Columns under the Action of Eccentric Loads”, 10.1061/ (ASCE) MT.1943-5533.0001352 (2015) American Society of Civil Engineers.
Maitham Alwash, Denys Breysse, Zoubir Mehdi Sbartaï, “Non-destructive strength evaluation of concrete: Analysis of some key factors using synthetic simulations”, Construction and Building Materials, Volume 99, 30 November 2015, Pages 235-245, ISSN 0950-0618.
Abdulkader El Mir, Salem G. Nehme, “Repeatability of the rebound surface hardness of concrete with alteration of concrete parameters”, Construction and Building Materials, Volume 131, 30 January 2017, Pages 317-326, ISSN 0950-0618
J. Helal, M. Sofi, P. Mendis, “Non-Destructive Testing of Concrete: A Review of Methods”, Electronic Journal of Structural Engineering 14(1) 2015.
Yun Yong Kim, Jin Man Kim b, Jin-Wook Bang, Seung-Jun Kwonc, “Effect of cover depth, w/c ratio, and crack width on half cell potential in cracked concrete exposed to salt sprayed condition”, Construction and Building Materials, February 2014,Pages 636–645.
G. Kilic, “Integrated health assessment strategy using NDT for reinforced concrete bridges”, NDT and E Int. 61 (2014) 80–94.
ACI 228.2R-98, Nondestructive Test Methods for Evaluation of Concrete in Structures ACI, American Concrete Institute Report, Farmington Hills, Michigan, 1998, p. 62.
B. Phares, Highlights of study of reliability of visual inspection, in: Proceedings: Annual Meeting of TRB Subcommittee A2C05 (1): Nondestructive Evaluation of Structures, FHWA Report No FHWARD-01-020 and FHWA-RD-01-0212001.
V. Gattulli, L. Chiaramonte, Condition assessment by visual inspection for a bridge management system, Comput.-Aided Civ. Infrastruct. Eng. 20 (2) (2005) 95–107.
Chung, H. W. "Ultrasonic testing of concrete after exposure to high temperatures." NDT international 18, no. 5 (1985): 275-278.
Komlos, K., S. Popovics, T. Nürnbergerová, B. Babal, and J. S. Popovics. "Ultrasonic pulse velocity test of concrete properties as specified in various standards." Cement and Concrete Composites 18, no. 5 (1996): 357-364.
Lin, G., J. Lu, Z. Wang, and S. Xiao. "Study on the reduction of tensile strength of concrete due to triaxial compressive loading history." Magazine of Concrete Research 54, no. 2 (2002): 113-124.
A. Glaubitt, S. Bussat and J. Nuisance, Reference concrete for ultrasonic-testing and its creation by components with pre-analyzed properties. In: Proceedings of the international symposium on NDT in civil engineering, Berlin (2003.)
Poursaee, A., Hansson, C.M., 2009. Potential pitfalls in assessing chloride-induced corrosion of steel in concrete. Cement and Concrete Research 39 (5), 391-400.
Poursaee, A., 2009. Automatic system for monitoring corrosion of steel in concrete. Advances in Engineering Software 40 (11), 1179e1182.
Sanjeev Kumar Verma, Sudhir Singh Bhadauria,and Saleem Akhtar, “Review of Nondestructive Testing Methods for Condition Monitoring of Concrete Structures”, Journal of Construction Engineering Volume 2013 (2013), Article ID 834572, 11 pages.
Ahmad Zaki, Hwa Kian Chai, Dimitrios G. Aggelis and Ninel Alver ,“ Non-Destructive Evaluation for Corrosion Monitoring in Concrete: A Review and Capability of Acoustic Emission Technique”, Sensors, ISSN 1424-8220 ,15, 19069-19101,2015.
IS 13311 (Part 2) :1992 (Reaffirmed 2004), “NON-DESTRUCTIVE TESTING OF CONCRETE- METHODS OF TEST”, PART 2 REBOUND HAMMER, Indian Standards.
IS 13311 (Part 2):1992 (Reaffirmed 2004), “NON-DESTRUCTIVE TESTING OF CONCRETE- METHODS OF TEST”, PART 1 Ultrasonic Pulse Velocity, Indian Standards.
IS 456:2000, “Plain and Reinforced Concrete- Code of Practice”, Fourth Revision, Indian Standards.
Peter Shaw, “Assessment of The Deterioration of Concrete in NPP Causes, Effects and Investigative Methods”, NDE Techniques Capability Demonstration And Inspection Quali Fication, Vol.3 No.2, February, 1998.
Katalin Szilágyi, Adorján Borosnyói, István Zsigovics, Rebound surface hardness of concrete: Introduction of an empirical constitutive model, Construction and Building Materials, Volume 25, Issue 5, May 2011, Pages 2480-2487, ISSN 0950-0618.
Shamsad Ahmad, “Reinforcement corrosion in concrete structures, its monitoring and service life prediction––a review”, Cement and Concrete Composites, Volume 25, Issues 4–5, May–July 2003, Pages 459-471, ISSN 0958-9465.
Eugen BRÜHWILER, Pierre MIVELAZ, “From Corrosion of Existing to Durability of New Concrete Structures”, IABSE Symposium - Rio de Janeiro - August 25-27, 1999.
Tarek Uddin Mohammed, Nobuaki Otsuki and Hidenori Hamada, “Corrosion of Steel Bars in Cracked Concrete under Marine Environment”, 10.1061/(ASCE) 0899-1561(2003)15:5(460).
Viktor Urban, Vit Krivy, Katerina Kreislova, “The Development of Corrosion Processes on Weathering Steel Bridges”, Procedia Engineering, Volume 114, 2015, Pages 546-554, ISSN 1877-7058.
Razmjoo and Poursaee, “Effects of Coarse Aggregates on the Corrosion of Steel Bars in Cement Paste”, 10.1061/ (ASCE) MT.1943-5533.0001569 (2016), American Society of Civil Engineers.
M. Goueygou, O. Abraham, J.-F. Lataste, “A comparative study of two non-destructive testing methods to assess near-surface mechanical damage in concrete structures”, NDT & E International, Volume 41, Issue 6, September 2008, Pages 448-456, ISSN 0963-8695.
Ngoc Tan Nguyen, Zoubir-Mehdi Sbartaï, Jean-François Lataste, Denys Breysse, Frédéric Bos, “Assessing the spatial variability of concrete structures using NDT techniques – Laboratory tests and case study”, Construction and Building Materials, Volume 49, December 2013, Pages 240-250, ISSN 0950-0618.
DOI: 10.28991/cej-030919
Refbacks
- There are currently no refbacks.
Copyright (c) 2017 Preethi Venkatesh
This work is licensed under a Creative Commons Attribution 4.0 International License.