Comparing the Effect of Nanomaterial and Traditional Fillers on the Asphalt Mixture Properties

Gholam Hossein Hamedi, Mohsen Sohrabi, Farhad Sakanlou

Abstract


Several parameters affect asphalt mix performance against loading and environmental conditions. Minor changes in the filler amount or type can cause obvious changes in the asphalt mixture properties. Accordingly, in this research attempts have been made to optimally make asphalt mixture strong against loading and environmental conditions by changing the type, size and percentage of filler used in asphalt mixture. In this line, the effect of two types of cement and nano-silica fillers in two different percentages was investigated and compared as an alternative for part of the main filler in asphalt mixture samples made by two types of limestone and granite aggregate. Cement filler by 2% and 4% of the aggregate mass as the alternative for part of the main filler is added to stone materials before mixing with binder, but nano-silica filler by 2% and4 % of weight of the binder as the alternative for part of the main filler is added to binder and a modified and homogeneous binder is produced using a high speed mixer. In the following, considering the optimum binder content for each mixture, resilient modulus tests were conducted to determine the strength performance against loading and indirect tensile strength ratio was used to determine moisture sensitivity of asphalt mixtures. Results obtained from resilient modulus tests show that the use of nano-silica and cement has been capable of favorably improving the resilient modulus of samples containing these two types of fillers. The improvement of the resilient modulus of samples containing nano-silica is very significant. Additionally, the studies conducted based on the indirect tensile strength ratio show that both types of alternative fillers, especially cement has been capable of desirably improve the strength of asphalt mixtures against moisture damage.


Keywords


Hot Mix Asphalt; Filler; Nanomaterials; Moisture Damage; Resilient Modulus.

References


Hamedi, Gh.H., and S.A. Tahami. “The Effect of Using Anti-Stripping Additives on Moisture Damage of Hot Mix Asphalt.” International Journal of Adhesion and Adhesives 81 (March 2018): 90–97. doi:10.1016/j.ijadhadh.2017.03.016.

Kennedy, Thomas W., Freddy L. Roberts, and KANG W. Lee. "Evaluating moisture susceptibility of asphalt mixtures using the Texas Boiling Test." Transportation Research Record 968 (1984): 45-54.

Moghadas Nejad, Fereidoon, Ehsan Geraee, and Ali Reza Azarhoosh. “The Effect of Nano Calcium Carbonate on the Dynamic Behaviour of Asphalt Concrete Mixture.” European Journal of Environmental and Civil Engineering (March 26, 2018): 1–10. doi:10.1080/19648189.2018.1456486.

Varveri, A., and Athanasios Scarpas. "Moisture damage susceptibility of asphalt mixtures: Experimental characterization and modelling." PhD diss., Delft University of Technology, 2017.

Moghadas Nejad, Fereidoon, Rashid Tanzadeh, Javad Tanzadeh, and Gholam Hossein Hamedi. “Investigating the Effect of Nanoparticles on the Rutting Behaviour of Hot-Mix Asphalt.” International Journal of Pavement Engineering 17, no. 4 (December 24, 2014): 353–362. doi:10.1080/10298436.2014.993194.

Kiggundu, Badru M., and Freddy L. Roberts. Stripping in HMA mixtures: State-of-the-art and critical review of test methods. No. NCAT Report No. 88-2. Auburn, AL, USA: National Center for Asphalt Technology, 1988.

Diab, Aboelkasim, and Mahmoud Enieb. “Investigating Influence of Mineral Filler at Asphalt Mixture and Mastic Scales.” International Journal of Pavement Research and Technology 11, no. 3 (May 2018): 213–224. doi:10.1016/j.ijprt.2017.10.008.

Chen, Meizhu, Juntao Lin, and Shaopeng Wu. “Potential of Recycled Fine Aggregates Powder as Filler in Asphalt Mixture.” Construction and Building Materials 25, no. 10 (October 2011): 3909–3914. doi:10.1016/j.conbuildmat.2011.04.022.

Azarhoosh, Alireza, Fereidoon Moghaddas Nejad, and Ali Khodaii. “Evaluation of the Effect of Nano-TiO2 on the Adhesion Between Aggregate and Asphalt Binder in Hot Mix Asphalt.” European Journal of Environmental and Civil Engineering 22, no. 8 (September 7, 2016): 946–961. doi:10.1080/19648189.2016.1229227.

Dan, Lv, Zheng Chuanfeng, Qin Yong, Bi Heng, Li Keyao, and Huang Junfei. “Analysing the Effects of the Mesoscopic Characteristics of Mineral Powder Fillers on the Cohesive Strength of Asphalt Mortars at Low Temperatures.” Construction and Building Materials 65 (August 2014): 330–337. doi:10.1016/j.conbuildmat.2014.04.123.

Roberts, Freddy L., Prithvi S. Kandhal, E. Ray Brown, Dah-Yinn Lee, and Thomas W. Kennedy. "Hot mix asphalt materials, mixture design and construction." (1991).

Enieb, Mahmoud, and Aboelkasim Diab. “Characteristics of Asphalt Binder and Mixture Containing Nanosilica.” International Journal of Pavement Research and Technology 10, no. 2 (March 2017): 148–157. doi:10.1016/j.ijprt.2016.11.009.

Chelovian, Asadollah, and Gholamali Shafabakhsh. “Laboratory Evaluation of Nano Al 2 O 3 Effect on Dynamic Performance of Stone Mastic Asphalt.” International Journal of Pavement Research and Technology 10, no. 2 (March 2017): 131–138. doi:10.1016/j.ijprt.2016.11.004.

Amirkhanian, Armen N., Fei-Peng Xiao, and Serji N. Amirkhanian. "Characterization of unaged asphalt binder modified with carbon nano particles." International Journal of Pavement Research and Technology 4, no. 5 (2011): 281-286.

Moghadas Nejad, F., A. R. Azarhoosh, and Gh. H. Hamedi. “Laboratory Evaluation of Using Recycled Marble Aggregates on the Mechanical Properties of Hot Mix Asphalt.” Journal of Materials in Civil Engineering 25, no. 6 (June 2013): 741–746. doi:10.1061/(asce)mt.1943-5533.0000539.

Ziari, Hassan, Asghar Habibnejad Korayem, Mojtaba Hajiloo, Mostafa Nakhaei, Amir Razmjou, and Hassan Divandari. “Evaluating the Effect of Amorphous Carbon Powder on Moisture Susceptibility and Mechanical Resistance of Asphalt Mixtures.” Construction and Building Materials 152 (October 2017): 182–191. doi:10.1016/j.conbuildmat.2017.06.036.

Faheem, Ahmed F., and Hussain U. Bahia. “Modelling of Asphalt Mastic in Terms of Filler-Bitumen Interaction.” Road Materials and Pavement Design 11, no. sup1 (January 2010): 281–303. doi:10.1080/14680629.2010.9690335.

Xie, Jun, Shaopeng Wu, Ling Pang, Juntao Lin, and Zuhuang Zhu. “Influence of Surface Treated Fly Ash with Coupling Agent on Asphalt Mixture Moisture Damage.” Construction and Building Materials 30 (May 2012): 340–346. doi:10.1016/j.conbuildmat.2011.11.022.

Sakanlou, Farhad, Hamid Shirmohammadi, and Gholam Hossein Hamedi. “Investigating the Effect of Filler Types on Thermodynamic Parameters and Their Relationship with Moisture Sensitivity of Asphalt Mixes.” Materials and Structures 51, no. 2 (February 24, 2018). doi:10.1617/s11527-018-1166-3.

Partl, M.N., R. Gubler, and M. Hugener. “Nano-Science and -Technology for Asphalt Pavements.” Special Publication (n.d.): 343–355. doi:10.1039/9781847551528-00343.

Liao, Gong-yun, Xiaoming Huang, and Dun-zhu Ba Sang. Antiultraviolet aging and antithermal-oxygen aging tests of asphalts adapting to environment of Tibetan plateau of China. No. 08-0308. 2008.

Jahromi, Saeed Ghaffarpour, and Ali Khodaii. “Effects of Nanoclay on Rheological Properties of Bitumen Binder.” Construction and Building Materials 23, no. 8 (August 2009): 2894–2904. doi:10.1016/j.conbuildmat.2009.02.027

Van de Ven, M, Jeroen Besamusca, and A Molenaar. “Nanoclay for Binder Modification of Asphalt Mixtures.” Advanced Testing and Characterization of Bituminous Materials (May 14, 2009). doi:10.1201/9780203092989.ch14.

Muller, Karl-Hans, Walter Barthel, and Rolf Oelmuller. "Process for improving the mineral asphalt coatings for streets and paths and products." U.S. Patent 4,410,589, issued October 18, 1983.

Enieb, Mahmoud, and Aboelkasim Diab. “Characteristics of Asphalt Binder and Mixture Containing Nanosilica.” International Journal of Pavement Research and Technology 10, no. 2 (March 2017): 148–157. doi:10.1016/j.ijprt.2016.11.009.

Grilli, Andrea, Fabrizio Cardone, and Edoardo Bocci. “Mechanical Behaviour of Cement-Bitumen Treated Materials Containing Different Amounts of Reclaimed Asphalt.” European Journal of Environmental and Civil Engineering 22, no. 7 (August 10, 2016): 836–851. doi:10.1080/19648189.2016.1219972.

Copeland, Audrey R. "Influence of moisture on bond strength of asphalt-aggregate systems." PhD diss., 2007.

ASTM, D. "Standard test method for determining the resilient modulus of bituminous mixtures by indirect tension test." ASTM International, West Conshohocken, PA (2011).

Sebaaly, Peter E. "Comparison of lime and liquid additives on the moisture damage of hot mix asphalt mixtures." Arlington (Virginia, USA): National Lime Association (2007).

Gorkem, Cagri, and Burak Sengoz. “Predicting Stripping and Moisture Induced Damage of Asphalt Concrete Prepared with Polymer Modified Bitumen and Hydrated Lime.” Construction and Building Materials 23, no. 6 (June 2009): 2227–2236. doi:10.1016/j.conbuildmat.2008.12.001.

Sebaaly, Peter E., D. N. Little, and J. A. Epps. "The benefits of hydrated lime in hot mix asphalt." Arlington (Virginia, USA): National Lime Association (2006).

Stuart, Kevin D. "Moisture damage in asphalt mixtures-a state-of-the-art report." (1990).

Tarrer, A. R., and Vinay Wagh. The effect of the physical and chemical characteristics of the aggregate on bonding. No. SHRP-A/UIR-91-507. Washington, DC, USA: Strategic Highway Research Program, National Research Council, 1991.

Hicks, Russell G. Moisture damage in asphalt concrete. No. 175. Transportation Research Board, 1991.


Full Text: PDF

DOI: 10.28991/cej-2019-03091247

Refbacks

  • There are currently no refbacks.




Copyright (c) 2019 Gholam Hossein Hamedi

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.
x
Message